wire saw machine control system

The rope saw mainly consists of two parts: the main machine and the wire saw machine control system (commonly known as operation station).

Kanghua rope saw machine is very different from the control system of his brand rope saw machine.
The wire saw machine control system transmits signals through transmission lines with the machine. When transmission failure occurs, workers in mining enterprises will be unable to carry out troubleshooting and maintenance. In contrast, the kanghua rope saw only has 6 cables, among which 2 are standby and only 4 are actually used. The failure rate and maintenance difficulty are greatly reduced. Even if the fault occurs, the fault will be displayed on the screen of the console without manual troubleshooting. The operator can replace the spare cable to achieve the purpose of maintenance.
The wire saw machine control system of kanghua rope saw provides the backup operating system. As can be seen from the operating station picture above, the surrounding buttons are the main operating system. When the operating system fails, the backup operating system can be immediately activated by the screen keys in the middle part of the console. No delay in production, no waiting for rescue.
All the buttons on the control table are waterproof and dustproof, which ensures the service life of the control system of the rope saw machine.
For safety reasons, the wire saw machine control system should be placed 5 to 10 meters away from the machine. You must be able to look directly at the cutting.